The UK government has confirmed a general safety requirement for construction products outside the current regime, with regulations due to be laid in 2027.
On 18 November the government published its response to the consultation on a general safety requirement (GSR) for construction products. It covers the products that sit outside designated standards and technical assessments, a central estimate of 63% of everything on the market.
What it means for designers
For MEP people this lands on the long tail: brackets, sealants, insulation, fixings, supports and anything without a designated standard. In practice the manufacturer's stated intended use and limitations become the document you specify against, so it is worth asking suppliers now how they will publish that information and getting it into your product data templates, including custom MagiCAD products, and O&M handover instead of hunting for it at the end.
Do your current specs and BIM objects actually carry intended-use and limitation data for these products?
Russian version: https://bim3d.org/threads/438/
On 18 November the government published its response to the consultation on a general safety requirement (GSR) for construction products. It covers the products that sit outside designated standards and technical assessments, a central estimate of 63% of everything on the market.
UK General Safety Requirement for Construction Products Confirmed
Exposed mineral wool insulation, cladding brackets and scaffolding on a facade under...
- Regulations will be laid in 2027 and come into force no earlier than 12 months after that.
- Manufacturers must assess safety risks, give accurate and up-to-date product information and monitor safety after products are on the market, including complaints and incidents.
- Importers check that the manufacturer has done the risk assessment and supplied the information and labelling. Distributors check the documentation and pass product information on.
- Records are kept for 10 years after the last supply of a product.
- Meeting a voluntary standard or holding third-party certification will not count as automatic compliance.
- The national regulator gets civil monetary penalties as an alternative to prosecution.
What it means for designers
For MEP people this lands on the long tail: brackets, sealants, insulation, fixings, supports and anything without a designated standard. In practice the manufacturer's stated intended use and limitations become the document you specify against, so it is worth asking suppliers now how they will publish that information and getting it into your product data templates, including custom MagiCAD products, and O&M handover instead of hunting for it at the end.
Do your current specs and BIM objects actually carry intended-use and limitation data for these products?
Russian version: https://bim3d.org/threads/438/
Last edited: