On a multi-floor plumbing layout, the soil stacks have to jog around beams and transfer zones. After those offsets are coordinated, I find the riser calculation and vent arrangement are the parts that take the most rechecking; a pipe size that looked fine on the straight run isnt the whole story once the branches move.
How do you size and model drainage risers in MagiCAD so the system stays coherent when the stack route changes?
I’d like to hear what checks have saved you from reworking stacks late in a project. If you have a repeatable workflow, please share the sequence you use.
How do you size and model drainage risers in MagiCAD so the system stays coherent when the stack route changes?
- Do you recalculate the full stack after every route change, or check affected sections separately?
- How do you handle offsets and branch connections in the model so the calculation reflects the actual layout?
- What do you include in the riser schedule to make review and coordination easier?
- How do you coordinate vent connections with structural openings and other services?
I’d like to hear what checks have saved you from reworking stacks late in a project. If you have a repeatable workflow, please share the sequence you use.
